Samsung users look over: S7 edge daily match recommended
Kunikwa, I am a good student
In a flash, iPhone 7 is coming soon
The S7 edge in his hand is about to complete its mission and retreat to the second line.
Counting this generation of S7 before and after buying 3
Sun shining silver
There is also a straight screen 9300 and this black Edge
After half a year spent, many small and large accessories
So with this small text, give everyone a daily accessories purchase recommendation
Note: The following are under the text above
Wireless chargingSamsung Vertical Three-generation Fast Charger Wireless Charger
Wireless charging is simply a conscience accessory that boosts the happiness index
Three generations changed to vertical placement, overall workmanship is good
There are two versions of white and black, black texture will be slightly better
The specification is 5V/2A 9V/1.67A, which is the same as the original charger and also meets the QC2.0 standard
On the back of the air guide, in actual use, the heat is not very obvious
Peripheral rubber ring, due to material
It is very easy to contaminate dust and particles, and is basically difficult to clean
The vertical experience is a lot better than the previous generation
The fuselage is about 1/4 higher than the charging board, as long as it is not like my son picks up and throws darts, the stability problem is not too big
No load 5V/0.02A, current still passes when not charging
Original charger, 40% charge, power 9V/1.42A
Somewhat worse than the 1.67A standard of QC2.0
Interestingly, the bright screen is charged
Wireless charger is close to 9V/1A, which is much higher than 9V/0.6A for line charging
Non-original QC2.0 charging heads and wires are also recognizable
Compared with wireless charging, charging time is not tested
Here are two ways of estimating machine time
It can be seen that wireless charging is still 10 minutes slower than direct line charging
â–³ Summary and Purchase Reference:
Three generations of wireless charging, vertical use experience is much better than the previous generation
It's easy to check the phone notification during charging
Excellent workmanship, but apron material is easy to dirty
Charging power is close to the original charger, also has a good charging speed
The price of 298 should be more conscientious than the price of Apple's future wireless chargers.
When the early S7 edge was released, Jingdong sent a lot of price-sensitive products that could go to free time or other second-hand websites to look for. The price should be more pleasantly surprised.
Overall, five stars recommend buying ★★★★★
Charger and data cableHere to talk about the choice of charging head and data line
Since the 8890 version overseas does not support QC3.0, so the country's 820 also only supports QC2.0.
As the charging time becomes more and more fragmented, and the need for outbound charging increases
An original charger can not meet the demand
In addition to the original adapter, I used Anker QC2.0 charging head
Pins are folded, making it easier to carry around
The power is consistent with that of the original factory and can reach the QC2.0 standard of 9V/1.67A
The photographs have been forgotten. When you are old, your brain is not good enough.
This is a long time ago Jingdong participated in crowdfunding
The normal price is now 99 yuan
Looked at Jingdong, the current mainstream QC2.0 charger
The price is basically between 39-100, the difference is still relatively large
If you care about the price more than work, the following paragraphs are also considered
Green Alliance, has always been the price killer in the charging community
Jindianbao, valued friends also had a single
QC3.0 penetration rate will increase substantially next year, now a QC3.0 charging head is also a good choice
Because of backward compatibility, 3.0 2.0-powered devices are no problem
Green Alliance is still the lowest price
Potato Chip Factory
JDB, 99 yuan dual port, while supporting Apple's agreement
Anker
If you need multiple QC chargers, please refer to my previous order
Next is the data line
Micro usb is now available to choose from
But I still recommend the right nylon material
Compared to the traditional wire on the left side, nylon is not easy to be entangled, dirty, and the appearance feels better than the former.
Put two links for reference. Remember that my nylon was last year's activity and more than 20 pieces were purchased.
Recalling mobile power, the mobile power industry has developed rapidly in the past two years
There are also many QC2.0 versions available in the market.
Just say I'm using it
Anker's 10050mAh, together with the above QC2.0 charger, was purchased as a crowdfunding kit.
Input voltage 5V/9V-2A
Output voltage 5V-2.4A, 9V-2A, 12v-1.5A
Bidirectional fast charge
Electricity is shown in a circle
QC2.0 logo on the back
However, the bottom of the capacity mark is easy to wear and it may be slightly inconvenient to pass the security check on the plane.
Empty
Access S7 edge, power is 8.85V/1.61A
QC2.0 standard close to 9V/1.67A
The phone shows fast charging
Two-way fast charge, when the Anker QC2.0 table is used to charge the mobile power, the power reaches 9V/2A
â–³ Summary and Purchase Reference:
After Anker's mobile power supply, crowdfunding, the size, weight, and appearance are all pretty good, they stayed around.
In addition to easy wear at the bottom of the logo, the metal shell is easy to bump, there is basically no slot
Overall, four and a half stars, more recommended purchase ★ ★ ★ ★ ☆
Car charger In the era of fragmentation, car chargers become more and more important, especially long-distance travel.
QC car charger is currently either single or expensive
My current use is a single-port QC car charger + 36W 3-port
Separately place the cigarette lighter on the front and back, remove the driving recorder, and 3 devices can be charged at the same time
36W 3 mouth can refer to my previous sun list
QC single port car charger or last crowdfunding
199 price, including QC mobile power, car charger, charger
It seems very cost-effective now
The picture forgot to shoot again, it is this
It is now off the shelf and replaced by the QC3.0 dual port
Green Alliance's QC2.0 dual port as long as 39, of course, appearance and workmanship, to pick bike series
If you want to take care of the value and more, you can also consider giving up QC.
After all, long distances, QC fast charging is not much faster than ordinary 5V/2A charging
When it comes to protective shells and foils, in fact, my heart is resistant.
Because sometimes it will go to some places where the environment is more severe, such as construction sites and the like.
What kind of sand will inevitably leave some traces on the phone?
This black edge is going to be put into the cupboard
So sometimes it will be covered with shells
The original shell was originally sent by Jingdong.
Full transparent hard shell
Holes are very accurate and lighter
However, the disadvantage of this shell is that it is very resistant to wear. The lower two corners are very brittle.
So I tried a lot more. The overall satisfaction is that this SPG shell
Hole is very accurate, the camera slightly raised some protective lens metal ring
There is only one Spigen logo on the back
The bottom hole can also be, because this generation of S7 border is silver, so some are not coordinated
Side key hole location is good
There are openings in the four corners of the machine for easy disassembly
The material of the shell itself is not too hard, plus the opening, it can be easily removed
Weight 19g, within acceptable range
Comparing iPhone6S 4.7 original leather case, only 1g
â–³ Summary and Purchase Reference:
Open hole is accurate, skin type material feels good, convenient disassembly
More wear-resistant, general anti-fouling, easy to contaminate sweat
Overall, four stars recommend buying ★★★★
Film:
Bought many films and walked a lot
It is not the tilt of the screen, it is the poor resolution and feel
Finally still feel that the kind of original membrane sent by Jingdong, relatively speaking, it is still relatively useless
This soft film is now easily available
This membrane is not covered in full, but it leaves a certain amount of space at the corners and at the top.
The top is flush with the handset
It's not too hard to stick together, and it doesn't use ancestral film
The overall fit is still awesome when posted, without any edging and disobedience
But everything is not perfect, the fatal flaw of this film
There are many irregular ripples on the membrane
The photo looks unusually ugly, and there is no photo so exaggerated in kind.
S7's home button, 10,000 years old plastic has been unable to Tucao
Don't say anything about polymer coating. "Scratching is just a molecular coating wear, who has nothing to rub home button"
When users use it, it takes too much
There is no reason to own your own pot
The front said that this black one should be put in the cupboard and still be kept intact
Tested several fingerprint films, and finally recommended this to everyone
Electrostatic fingerprinting film, a paste of 12
Pay attention to the need to buy static electricity, because the adhesive tape is very easy to stick high-tech polymer coating
Yes, this is very dark technology
Good effect
There are some differences between the gloss and the machine. If you look at the material, the above is not very smooth.
In terms of unlocking speed, subjective feeling basically has no effect
But this film is not wearable and it is a consumable item
Basic need to change once a week, but fortunately the price is not expensive
As for the rear camera protection film and the like
No need at all, the chance of grinding in this position is not great
After that, I will say no time.
We’ve heard countless truths but it’s still not good enough for this life
"We have posted numerous films, but it is still not good for S7."
So I already did it
Achieve a mobile phone and cultivate yourself
â–³ Summary and Purchase Reference:
The screen film is the best one I have used, and it will not be used for a long time.
Some initial astringent feel, gradually normal after a few days.
However, the film ripple problem is more serious
Overall, two stars recommended, just need to enter ★ ★
Fingerprint electrostatic film is easy to use and basically has no effect on fingerprint unlocking
Although the flatness and gloss are slightly worse, but it is still OK without looking
Overall, four-star recommendation, ★ ★ ★ ★
Finally, if you are interested in digital products and mobile phones
Welcome to pay attention to me, the first time in a few days will also bring a long review of the iPhone7 and plus
Thanks a prayer
End...