LED bulb design ideas: the surface temperature of the shell is different [disassembly]

Related links: Asian enterprise LED bulb design ideas difference analysis [full version]

Before disassembling, first measure the temperature of the LED bulb in the lighted state (Figure 2, Figure 3). The purpose is to confirm whether the difference in the base (heat dissipation) that is significantly different in appearance is reflected in the temperature. The light from the LEDs contains very little infrared light, so the part of the lamp that is illuminated by the light is not too hot. However, the base is the heat sink of the LED chip , so the temperature is high. At this time, a tape having an emissivity of 0.95 was attached to a portion where the base was the hottest (near the mounting position of the LED), and the temperature of the tape was measured by a thermal imager.

Among the 9 LED bulbs, the highest surface temperature of the base is the 7.2W product of Toshiba Lighting Technology (Fig. 2(b)). Comparing in Group A, Samsung LED's 7.1W product is about 47°C, Qinshang Optoelectronic 's 7.5W product is about 43°C, and Toshiba Lighting's 7.2W product is about 61°C, which is higher than these two models. 14 to 18 ° C.

Figure 2: Temperature measurement of LED bulbs in group A (click on image to enlarge)

Note: A tape with an emissivity of 0.95 was attached to the base of the LED bulb, and the temperature of the tape was measured using a thermal imager "TH6300" from NEC Avio Infrared Technology. A tape having an emissivity of 0.95 was used in order to unify the emissivity at the measurement position to 0.95. By measuring the temperature on the tape, an accurate temperature can be obtained. The closer the emissivity is to 1, the better the heat sink will be. In addition, the temperature measurement was assisted by the representative of the Thermal Design Laboratory, Guo Feng Shangshu. The measurement performed after lighting the LED bulb for more than 10 minutes. Toshiba Lighting's 7.2W product has a lower emissivity due to its lower emissivity, but the actual surface temperature is lower, but it is actually as high as 61 °C.

Laser Instrument Shell Packaging

Laser Instrument Shell Packaging,Gtms Enclosure With Gold Plating,Glass To Metal Sealed Enclosure With Gold Plate,Glass To Metal Sealed Enclosure Terminal

Shenzhen Capitol Micro-Electronics Co.,LTD , https://www.capitolgtms.com