The installation of the split microwave can be divided into two parts, an indoor part and an outdoor part. The installation of the indoor part is similar to the installation of the box type device, so the main part is the installation of the outdoor part.
The installation of the outdoor part is mainly the installation of the antenna and the ODU , and is divided into a straight button type installation and a separate type installation. The straight-button installation does not require a feeder, and the ODU is directly connected to the antenna. The separate installation uses the feeder to connect the ODU to the antenna. During the antenna pitch or level adjustment, the maximum voltage position is pitch or horizontal. The main lobe position of the direction, no need to make a large range adjustment in this direction, just fine tune the antenna to the maximum voltage position. The method of adjusting the pitch and level of the antenna is the same. When the antenna pair is not accurate, it is possible to measure only a small voltage in one direction. In this case, the two ends need to be matched, and the coarse adjustment is performed to roughly align the antennas at both ends. During the antenna pitch or horizontal adjustment process, once the received signal indicates the maximum point position of the voltage, that is, the main lobe position in the pitch or horizontal direction, the direction does not need to be adjusted in a large range, and only the antenna is finely adjusted to the maximum voltage point. can. The method of adjusting the pitch and level of the antenna is the same. When the antenna pair is not accurate, it is possible to measure only a small voltage in one direction. In this case, the two ends need to be matched, coarsely adjusted, and the antennas at both ends are roughly aligned, and then fine-tuned. Capacitor Motor
Capacitor Motor,Furnace Capacitor,Start Capacitor,Capacitor Start Motor
Wentelon Micro-Motor Co.,Ltd. , https://www.wentelon.com